Camus dynaflame manual

DynaFlame Condensing In this series most of the sensible heat value is being transferred into the water. The unused portion of the sensible heat and most of the latent heat is absorbed by the Condenser Heat Recovery Module (CHRM). Figure 2: DynaFlame Condensing SPECIAL INSTRUCTIONS TO OWNER This manual supplies information for the installation. The Camus DynaFlame offers models ranging from , BTU to 6 million BTU — the first for this style of boiler/water heater. All models are available in non-condensing, near-condensing or fully condensing modes. Applications: education, commercial and government buildings, water treatment plants and wineries.  · Hello all. I am new here. Licensed plumber in Canada with Class 1 gas ticket. I work in the commercial industry doing service. I have a question. I have a Camus Dynaflame that is shutting off on flame failure. The VFD is reading "OF" when I check the manual. OF means: Output Transistor Fault: Phase to phase or phase to ground short circuit on the output; Boost .

Bms Camus Camus Product protocol setup Rev Dynaflame Manual-Dynaflame Rev() Manual-DynaFlame Rev() Manual-DynaFlame Rev The DynaFlame is a forced draft appliance utilizing a premix power burner based on push through design which offers several venting options. Heat output is controlled by a one to one air/gas ratio control gas valve which provides seamless modulation. The DynaFlame provides central heating and/or domestic hot water at working pressure up to PSI. trained by Camus Hydronics. The serviceman must utilize a combustion analyzer with CO 2, CO, and draft gauge, to set the appliance according to Camus Hydronics’ recommendation s, prior to commission ing. NOTE RETAIN THIS MANUAL FOR FUTURE REFERENCE CHECKING EQUIPMENT Check for signs of shipping damage upon receiving equipment.

Dynaflame. DMNC DMNH SB CTR. Viessman. CTW. - Viessman. Thermal Solutions. Camus Hydronics. EVCAB. 3 Connection from DynaFlame/DynaForce to ProtoNode. Run www.doorway.ru and follow the installation instructions Once installed, the FieldServer Utilities. Low water cut off (manual or automatic reset) The DynaFlame® is controlled by an integrated Honeywell SOLA controller. The 7” color touch screen.