Hydrovar vfd manual

By attaching one of the additional control cards to the BASIC Inverter the HYDROVAR can be upgraded either to the so called SINGLE or the MASTER Inverter. BASIC Inverter – HYDROVAR BASIC unit (not available for HV – ). Application: Sequence pump in a multi pump system, SINGLE pump operation as soft-starterEnclosure class: IP Expanded capabilities, easier than ever Hydrovar is the intelligent pump controller that matches the performance to system demand. The Hydrovar is easily mounted directly on the motor of the pump and will fit on any standard TEFC NEMA motor. This makes the Hydrovar an excellent choice for retrofitting and upgrading of fixed speed systems. There’sRead more. HYDROVAR is an intelligent controller that matches pump performance to demand. It controls the speed of a standard IEC motor by converting the fixed voltage and frequency from the power supply line. It can be fitted easily to any new pump system or retrofitted to existing pumps using the fast and easy “clip and play” mounting clamps.

A manual start up is always possible, even the HYDROVAR is equipped with a control card. For example, if it is necessary because of safety reasons to operate the BASIC Inverters when the MASTER Inverters fail, it is possible to equip this terminal with an AUTO/MANUAL switch. Hydrovar is the intelligent pump controller that matches the performance to system demand. The Hydrovar is easily mounted directly on the motor of the pump and will fit on any standard TEFC NEMA motor. This makes the Hydrovar an excellent choice for retrofitting and upgrading of fixed speed systems. There’s no need for an external control. manual for further information. Push the right arrow key to P Pump Address. If selecting cascade serial (multi pump) each address will have to be different. Example: One Hydrovar has address 1, and the next unit requires address 2. Push the right arrow key to P Control Mode and select Constant for constant pressure, and differential for.

Manual HV SVENSKA Styrkort – HYDROVAR ENKEL-inverter (finns inte för HV – HV använder en VFD på varje pump. are the result of a failure to comply with the operating instructions. This manual is intended to assist in the installation, operation and repair of the. they must be suitable for VFD's (see also chapter ). HV – HV switch S1 and S2 S1 – used only for internal high voltage testing.